Anonymous
Not applicable
Feb 23, 2015
02:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 23, 2015
02:16 AM
Per this thread here: Re: BCM20737S recovery problems
I'm in the completely same trouble using a FTDI 3.3V torelant UART bridge. Really hoping to get any solution.
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Feb 26, 2015
04:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 26, 2015
04:37 PM
Thanks for the comments everyone, and sorry for the mixing up.
As mwf_mmfae mentioned, I use multiple sensors and I found that caused the problem.
One of the I2C device was un-powered at the resetting moment because it is a multi power source circuit, then the u-powered device sunk the I2C bus power.
We solved all the issue.Thanks a lot!
14 Replies