MBT.exe and TAG4 board

[Gugi_2434611]

Does anyone know how to set the TAG4 board switches so i can use the MBT.exe tool to test the Bluetooth regulatory part.   Basically how to set the TAG4 board switch to enable HCI command and then i can use the Manufacturer Bluetooth Test Tool (mbt.exe).

Thanks

G

[DheerajPK_41 · Accepted solution]

Hi,

mbt tool basically sends HCI command to the device and waits for an HCI Command Complete event from the device. You can use it to test the Bluetooth radio and RF performance.

Please follow the instructions given in the below user guide. (Check "UART Boot-Up" section in page number: 11). Those instructions will enable the device to accept HCI commands or download firmware through the UART interface. Please try it.

https://community.cypress.com/servlet/JiveServlet/previewBody/2920-102-1-3095/920737TAG04-HWUM101-R....

Some of the useful links are given below. Please have a look.

Leveraging TAG4 to better understand the WICED Smart Programming Environment

WICED Smart Quick Start Guide (SDK 2.x and TAG4 Board)

Tag 4 Platform Specific Hardware Information

Thanks,

-Dheeraj