- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to use a spectrum analyzer to measure the carrier freq offset and drift and other physical layer measurement with the Wiced Sense at both NOC and EOC. I want to know what document, test software, setting and command that I should use to set it into hte test mode for the Tx measurement. Appreciated if someone can provide any input to assist me.
Solved! Go to Solution.
- Labels:
-
Manufacturing and Test
-
SDK 2.X
-
WICED Sense
- Tags:
- ble
- carrier frequency drift
- carrier frequency offset
- mbt
- test mode
- transmission testing
- tx test
- wiced sense
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If the design has an exposed UART, take a look at the Manufacturing Bluetooth Test Tool Application Note (SDK 2.1 and TAG3 Board)
If an exposed UART is not available, user subash figured out how to run some Tx based tests using one of the APIs:
Re: How to lock Tx on a particular channel?
Re: How to lock Tx on a particular channel? (Con't)
In addition, there is also a good blog here on RF testing: BLE RF Testing Setup Procedures