cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Smart Bluetooth

Anonymous
Not applicable

Hello,

During debug, my WICED Sense2 became a brick.

I tried to recover with WICED Sense Recovery Procedure Video.

However I can't find a boot button on the board and following recover command fails.

wiced_sense2-BCM920737TAG_Q32 recover UART=COMxx

**** Recovery failed - retry ****

How can I recover WICED Sense2?

Best regards,

Nori Shinozaki

0 Likes
1 Solution
BoonT_56
Employee

Download a copy of the wiced sense 2 FW from the below link:

WICED Sense 2 Firmware

Then try this:

1) Press and hold "Reset"

2) Insert USB cable

3) Ensure the two usb-to-serial ports are displayed under Device_Manager\Ports

4) Release "Reset"

5) Do a CLEAN before you compile and download

I used "wiced_sense-BCM920737TAG_Q32 recover UART=COM26" on a sense_2 kit.

View solution in original post

4 Replies
MichaelF_56
Moderator
Moderator

Adding btta

0 Likes
BoonT_56
Employee

Download a copy of the wiced sense 2 FW from the below link:

WICED Sense 2 Firmware

Then try this:

1) Press and hold "Reset"

2) Insert USB cable

3) Ensure the two usb-to-serial ports are displayed under Device_Manager\Ports

4) Release "Reset"

5) Do a CLEAN before you compile and download

I used "wiced_sense-BCM920737TAG_Q32 recover UART=COM26" on a sense_2 kit.

View solution in original post

Anonymous
Not applicable

Thanks, it worked!

Nori Shinozaki

0 Likes
BoonT_56
Employee

"Reset" is the little hole at the back of the dongle, and you will need a needle or safety-pin to press-and-hold a little button in the package.

0 Likes