- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I used to use AVR then, recently begin to use Broadcom's BLE module "BCM20737S".
But I don't get how to configure IO register's(ex.gpio,pwm,a/d converter) in BCM20737S. What document can I refer ?
I don't know why, but they aren't exist in datasheet...
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
embeddedmasters has done an excellent job explaining how to configure GPIO on our part within the datasheet for their Embedded Masters Break-Out Board: http://www.cdiweb.com/datasheets/embedded/EMRF-BCM20736S-BOB-UserManual.pdf
Start on page 49.
In addition, the new Smart Designer feature in SDK 2.X can also be used to setup GPIO.
j.t put together an excellent 'How-To' video here: WICED Smart Video BLOG: SDK 2.1 Smart Designer Tool Walk-Thru
When using this tool, pay particular attention to the "To-Do' list as these are sections of code that still need to be manually programmed. Smart Designer does the rest.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you read the Hardware Interfaces Document? WICED™ Smart Hardware Interfaces
Access to the low level I/O registers is usually not possible, as BCM has created an abstraction layer on top of them and provided the APIs to ask the hardware to do the work.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
embeddedmasters has done an excellent job explaining how to configure GPIO on our part within the datasheet for their Embedded Masters Break-Out Board: http://www.cdiweb.com/datasheets/embedded/EMRF-BCM20736S-BOB-UserManual.pdf
Start on page 49.
In addition, the new Smart Designer feature in SDK 2.X can also be used to setup GPIO.
j.t put together an excellent 'How-To' video here: WICED Smart Video BLOG: SDK 2.1 Smart Designer Tool Walk-Thru
When using this tool, pay particular attention to the "To-Do' list as these are sections of code that still need to be manually programmed. Smart Designer does the rest.