Anonymous
Not applicable
Sep 24, 2015
01:25 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2015
01:25 AM
Hi
I'm using P4 pin as an interruption pin to wake up from deep sleep.
When a rising edge is detected, the system wakes up from deep sleep.
However, I think that it doesn't wake up immediately with the tag3 reference board. I think it is the same in the case of the other interruption option, e.g. falling edge.
Does this work correctly? If so, please tell me how much time takes to do it.
Best regards
Solved! Go to Solution.
Labels
- Labels:
-
GPIO
-
Sleep Modes
1 Solution
Sep 24, 2015
01:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2015
01:54 AM
This blog, under the header "Wake time from deep sleep", may give some insights...
1 Reply
Sep 24, 2015
01:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2015
01:54 AM
This blog, under the header "Wake time from deep sleep", may give some insights...