- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good morning, I tried to enable CYBT343026 bluetooth module by HCI Uart commands, but I can't see it trought bluetooth of my smartphones.
To send commands to BT module I use CyBlueTool.
I've enabled radio, set tx power, assigned name to device and bd_addr, but without success.
What did I forget?
Thanks in advance for your help.
Regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi StDa_4617271,
Can you please check if reset command is giving a success in CyBluetool logs? Make sure you have opened HCI COM port in CyBluetool. If reset shows success, then try sending 'read BD_address' command and check if you can see device BD address in your logs.
If yes, then you can send start advertising command and try scanning device in your smartphone.