- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm looking for the procedure to udpate FW of CYBT-343026 from Host CPU and OTA.
Q1: Is there any good document and sample source code to update FW from Host CPU.
I think HCI UART under programming mode could be used by we are not sure host CPU control side.
Q2: Does CYBT module support OTA FW update?
If so , is there any sample application and smartphone application?
Thank you.
--TAK
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For downloading to CYW20706, you can use UART HCI.
Please go through WICED HCI UART Control Protocol pdf (/20706-A2_Bluetooth/doc/WICED-HCI-Control-Protocol.pdf) available in WICED studio for the downloading process flow.
OTA FW upgrade example project and peer app is available in the WICED studio. Please refer the same.
Location: /20706-A2_Bluetooth/apps/snip/ota_firmware_upgrade
Regards,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For downloading to CYW20706, you can use UART HCI.
Please go through WICED HCI UART Control Protocol pdf (/20706-A2_Bluetooth/doc/WICED-HCI-Control-Protocol.pdf) available in WICED studio for the downloading process flow.
OTA FW upgrade example project and peer app is available in the WICED studio. Please refer the same.
Location: /20706-A2_Bluetooth/apps/snip/ota_firmware_upgrade
Regards,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Anjana
Thanks for your prompt update.
Let me check.
BTW, the directory of documents is follows if using WICED 5.1 and 6.1 as follows.
<WICED Install Directory>\Doc
This is for just in case.
--TAK