Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I'm looking for the value of the pullup/pulldown resistor values/currents, but can't find it on the module datasheet, can you tell me what they are? Also, I am connecting one of the inputs to a pushbutton switch and need to remove some electrical noise so was going to use a parallel capacitor, but was worried about latch-up if directly connecting the cap to a pulled up or pulled down line but would like to not have to use an extra series resistance on the input if it wasn't needed. Is there an equivalent electrical schematic or recommendation on this?