cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Smart Bluetooth

Juar_2150386
New Contributor II

Hi,

Is it possible to debug a CYW20736S on custom board with a JLINK?

I see nothing in the datasheet (hardware recommandation) ? What J-Link is recommended ?

Thanks

0 Likes
1 Solution
MichaelF_56
Moderator
Moderator

Unfortunately, a document that maps the pins for the SOC to the debugger does not exist.  Only the Help Article noted above which uses the TAG3 board.  The schematic for the TAG3 board is in the Hardware User Guide (SDK 2.x and TAG3 Board)

View solution in original post

3 Replies
MichaelF_56
Moderator
Moderator

Debugging on this device is limited.

The only debugger I'm aware works/tested is described here: WICED Smart J-Link Debugger 

This post discusses alternatives: Segger J-Link debugger alternative

0 Likes
Juar_2150386
New Contributor II

Thanks

Do you have an AN to know witch PIN of the BCM20736S is used to plug the J-Link debugger?

0 Likes
MichaelF_56
Moderator
Moderator

Unfortunately, a document that maps the pins for the SOC to the debugger does not exist.  Only the Help Article noted above which uses the TAG3 board.  The schematic for the TAG3 board is in the Hardware User Guide (SDK 2.x and TAG3 Board)

View solution in original post