- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
For our manufacturing process we will need to configure our device with a MAC address. I was thinking to do this by communicating via the peripheral UART during a manufacturing test process. If my software knows the MAC address to use, how can I install it in the device?
Also, what are the guidelines on selecting MAC addresses? Is there a certain range we should use or do we need to acquire a range from an authority?
Solved! Go to Solution.
- Tags:
- mac address
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello idgirod,
Did you see our post: BD_ADDR: Changing your Board Address for Development and Production
Did you solve this issue?
Thanks
JT
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello idgirod,
Did you see our post: BD_ADDR: Changing your Board Address for Development and Production
Did you solve this issue?
Thanks
JT
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, I think this question has been answered.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you.
JT