- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Start the BlueTool(ver0.1.55.1) application,save the UART option,then set the following options:
a、Select7.3:Host Controller & Baseband Commands from the command list, then double-click the
Reset command.After double-clicking the Reset command, the log window should indicate Success for the reset
status.
b、Select7.3:Host Controller & Baseband Commands from the command list, then double-click the
Write_Scan_Enable(Inquiry and Page Scan enabled) command,the log window should indicate Success.
c、Select7.6:Testing Commands,then double-click the Enable_Device_Under_Test_Mode command,
the log window should indicate Success.
Try to connect 20734,the log window event = 0x04(Connection Request), Link_Type = 0x01("ACL connection") ,a few seconds later,the log window event = 0x03(Connection Complete),Status = 0x10(Connection Accept Timeout Exceeded)..
What else step can I do to solve this problem?By the way,is there an instruction manual for testing CE?
Solved! Go to Solution.
- Tags:
- cyw20734
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi gahe_4691766 ,
As the 20734 is not designated as a broad market device that is supported here on the community, please work with the local Cypress sales/distribution team for the queries.
Regards,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi gahe_4691766 ,
As the 20734 is not designated as a broad market device that is supported here on the community, please work with the local Cypress sales/distribution team for the queries.
Regards,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks!