Anonymous
Not applicable
Feb 28, 2014
12:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 28, 2014
12:22 PM
Hi,
In the 20732 SoC datasheet, it mentions that it fully supports Bluetooth Test Mode. I'm assuming then that it is also supported in the 20732S module. How is this mode activated in the module?
Is this mode "automatically" activated on power on if the HCI UART is connected?
Or is it related to the TMC pin (pull high)? Although, based on the post "Documentation on use of TMC pin?", the TMC pin is not available.
Thanks,
Mike
Solved! Go to Solution.
1 Solution
Mar 06, 2014
10:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 06, 2014
10:02 AM
> If the HCI UART is connected to on power on, can HCI commands for testing just be sent to the module then?
Yes, they can be.
3 Replies