cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Smart Bluetooth

Anonymous
Not applicable

Hi,

In the 20732 SoC datasheet, it mentions that it fully supports Bluetooth Test Mode. I'm assuming then that it is also supported in the 20732S module. How is this mode activated in the module?

Is this mode "automatically" activated on power on if the HCI UART is connected?

Or is it related to the TMC pin (pull high)? Although, based on the post "Documentation on use of TMC pin?", the TMC pin is not available.

Thanks,

Mike

0 Likes
Reply
1 Solution
Employee

> If the HCI UART is connected to on power on, can HCI commands for testing just be sent to the module then?

Yes, they can be.

View solution in original post

0 Likes
Reply
3 Replies
Anonymous
Not applicable

Hello myang,

Correct.  The TMC Pin is used by our internal Broadcom Automated Test Engineering and is not available.

JT

0 Likes
Reply
Anonymous
Not applicable

Thanks for the response.

What would be the suggested way to test the Bluetooth module during production? (If the HCI UART is connected to on power on, can HCI commands for testing just be sent to the module then?)

Thanks.

Mike

0 Likes
Reply
Employee

> If the HCI UART is connected to on power on, can HCI commands for testing just be sent to the module then?

Yes, they can be.

View solution in original post

0 Likes
Reply