Anonymous
Not applicable
Feb 26, 2015
06:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 26, 2015
06:49 AM
Hi,
the puart interface on the TAG doen't function anymore.
I used a Silicon Labs USB bridge to communicate with the TAG over puart, but now the RxD pin of the TAG (P8/P33) stay LOW.
I'm sure the TxD pin of my USB bridge works, on the oscilloscope the signal stay HIGH until I connect it withe the TAG, then it goes down.
How can I solve that problem?
Labels
- Labels:
-
Peripherhal UART
15 Replies