- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have the intention to use BCM20732S for my new project. As my PCB size is rather small, i have some limitation on the spcae for BCM20732S.
On the layout, please refer to page 23 of module datasheet.
My questions:
1) In the first picture above, the L-shape GND is on the top layer? Meaning to say we can actually route traces and place components inside? Or it simply means the whole L-shape GND on top layer must be cleared?
2) 2nd picture, this should be a 2nd layer GND (internal). Meaning to say it has to be in one whole big piece without any breaksge? Or can I follow the shape from the 1st picture above?
In simple context, for the L-shaped GND, if it is meant for Antenna use, can I lay components and route traces on top of the L-shaped GND, but i will make sure there is no breakage of the GND along the way if this L-Shaped GND is on the top layer?
Thanks
Kelvin
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please send an email to communities-list@broadcom.com and I will email you the document I have today.
It's rough and is unsupported, but you may find it helpful.