cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

UnHa_3846631
New Contributor

Hi all,

I want to configure the board as follows.

FPGA <-> FX3 <-> PC (USB 3.1 Gen 1)

At this time, the interface between the FPGA and the FX3 is conceived as a stream in method of the slave FIFO.

The main function is to transfer video data to PC, but I want to use UART communication together.

In case of not transmitting video data, UART communication between PC, FX3 and FPGA is tried to send and receive commands.

If you can, please let me know if you can configure the board in this way.

0 Likes
1 Solution
SrinathS_16
Moderator
Moderator

Hello,

Please refer to the project attached in the below thread.

Can EZ-USB FX3 enumerate serial devices and video and video devices at the same time?

Best regards,

Srinath S

View solution in original post

0 Likes
1 Reply
SrinathS_16
Moderator
Moderator

Hello,

Please refer to the project attached in the below thread.

Can EZ-USB FX3 enumerate serial devices and video and video devices at the same time?

Best regards,

Srinath S

View solution in original post

0 Likes