cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

Anonymous
Not applicable

Hello: When I create a UVC+HID compliant device, I encounter a problem. After the UVC and HID enumeration is completed, the host issues the SET FEATURE command (content: 01 03 00 00 02 01 00 00) when the host sends this. After the command, HID cannot send a report, but UVC works normally. If I start UVC and send a report to start HID before the host sends SET FEATURE, both UVC and HID are working properly. Why?

0 Likes
Reply
1 Solution
Employee

Hi

Do you use Win7 or Win10?

View solution in original post

0 Likes
Reply
3 Replies
Anonymous
Not applicable

hi: this is my descriptor,  used uvc stream uvc control and hid  three interface!  thanks advance!

0 Likes
Reply
Moderator
Moderator

In the first case (HID not working one), what the device response to the Report?

Can you share the uvc.c file for the review?

0 Likes
Reply
Employee

Hi

Do you use Win7 or Win10?

View solution in original post

0 Likes
Reply