- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sir,
i built our product image on SDK1.2 (with necessary modificaitons, e.g. the new "cyfx_gcc_startup.s" file and the "cyu3lpp.a" in linker option...etc.)..the building was fine...but the code blocked at the point an external interrupt occurred on a simple IO pin. (the pin is configured properly with "Negative_Edge" interrupt enabled)
The same source code was built on SDK V1.0, V1.0.1 and V1.1 and worked fine.
Then i tried the "GPIOApp" example included in the SDK1.2 and tested it on DVK board and it seems having the same issue.
Is there additional anything should be done for interrupts of simple IO with SDK1.2?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I met the same issue...
regards
Lumpi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The test application from Cypress "cyfxgpioapp" don't work.
If you change the input inerrupt trigger from "CY_U3P_GPIO_INTR_BOTH_EDGE" to "CY_U3P_GPIO_INTR_NEG_EDGE", the application will run. The use of "CY_U3P_GPIO_INTR_POS_EDGE" will get the application to hang.
Poul-Erik.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I have the same problem when I try to read the state of the GPIO
regards
Athos
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Guys,
There is a bug in the handling of the GPIO interrupts in the SDK 1.2.
You need a library patch to fix this issue. I don't think I can share the new SDK build with the fix here.
So, Please create a tech support case to get the new SDK build.
Thanks,
sai krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ayi,
I will update you on the release date soon.
Thanks,
sai krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ayi,
It is going to be released in around 2 weeks from now. I will update you if it is going to be delayed for some reason.
Thanks,
sai krishna.