- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Sirs,
how to send debug info to host via USB?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Refer USBDebug example part of FX3 SDK. Refer CyU3PDebugInit() API.
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
many thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You are welcome
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Sirs,
How to use debug endpoint of interrupt type along endpoint of bulk type?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I define new endpoint as well as at debugInit example, initiate endpoint, but endpoint didn't occur at control center.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You'll need to add an endpoint descriptor correspoinding to the bulk/interrupt endpoint.
After doing so, make sure to change the "number of endpoints" (bNumEndpoints) parameter of the interface descriptor and the overall length in the configuration descriptor.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you scutifer! I have found this several minutes ago. But How to calculate overall length? And Do I have write something about debug endpoint there.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there anyone can let me know how to check whether the device's interrupt IN endpoint works with a host PC?
When I download the firmware, my PC can detect the device as 'Cypress FX3 USB BulkloopExample Device' in the USB Control Center.
However, I do not know how to test it work with the USB Control Center.
Can anyone help me?