cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

gean_3054931
Contributor II

Hello,

can anybody reply to below thread?

FX3 JTAG SEGGER

thank you

0 Likes
1 Solution
KandlaguntaR_36
Moderator
Moderator

It is answered in thread FX3 JTAG SEGGER

Please set the following breakpoints in the firmware and do stepover at KernelEntry

By default the debugger stops at Main.

1. Put a break point at application define function (CyFxApplicationDefine)

2. Otherone at Thread_Entry function (for example - UVCAppThread_Entry in UVC An75779 firmware )

After this, if you do stepover at kernelentry, it will take you to Application Define. Then it will take you to Thread_Entry.

Hope this solves your problem.

I have tested at my end. It is working fine.

View solution in original post

0 Likes
1 Reply
KandlaguntaR_36
Moderator
Moderator

It is answered in thread FX3 JTAG SEGGER

Please set the following breakpoints in the firmware and do stepover at KernelEntry

By default the debugger stops at Main.

1. Put a break point at application define function (CyFxApplicationDefine)

2. Otherone at Thread_Entry function (for example - UVCAppThread_Entry in UVC An75779 firmware )

After this, if you do stepover at kernelentry, it will take you to Application Define. Then it will take you to Thread_Entry.

Hope this solves your problem.

I have tested at my end. It is working fine.

View solution in original post

0 Likes