- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried with the given example project "GPIOApp" to toggle the gpio21 pin, but i am not finding any changes.
Solved! Go to Solution.
- Labels:
-
ispn:38621:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
With the original firmware and supposing your kit has no hardware problem, you will see GPIO 21 is toggling after booting.
I suggest you to check if the firmware reports any error message when intialize and boot.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Do you change anything in the example project? How do you observe the output of GPIO21? By an oscilloscope?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i changed gpio21 to gpio45 and in scope that pin in showing high
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
With the original firmware and supposing your kit has no hardware problem, you will see GPIO 21 is toggling after booting.
I suggest you to check if the firmware reports any error message when intialize and boot.