- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm using MAX2084EVKIT in that evaluation kit CYUSB3014-BZXC placed.
(1) I used this setup in windows 10 it detects and worked.
(2) But I connected to the windows 7 it doesn't respond to anything.
(3) I checked with device manager in windows 7 it doesn't show anything about cypress driver.
(4) Earlier in windows 10, it shows Westbridge and I updated the driver software
(5) clearly, I understood it doesn't respond in Windows 7 and I reconnect with the windows 10 no response there also.
(6) Please tell me the procedure what I have to do further activate the max2084 evkit via cypress
Awaiting for your response
Thanks & Regards,
Chandran. Bose
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Cahndran,
Please install the tool USBlyzer(30 days trial) or BUS HOUND(not free) to capture the USB trace after you connect your board to PC.
It will help us to anallyze this problem.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Chandran,
- Please let me know if the device comes up with error mark on Windows 7. Kindly, check under the 'USB controllers' section and the 'Unknown Devices' section.
Best regards,
Srinath S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Cahndran,
Please install the tool USBlyzer(30 days trial) or BUS HOUND(not free) to capture the USB trace after you connect your board to PC.
It will help us to anallyze this problem.