- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I purchased the cyusb3kit-003 board.
However, if you try to download the IMG file to the I2C EEPROM of the board through the USB Control Center, the message "Programming of I2C EEPROM Failed" will appear and the download will fail.
When connecting USB to PC, "Cypress FX3 USB BootLoader Device" is connected.
Pmode (J4) Jump is shorted.
Solved! Go to Solution.
- Labels:
-
ispn:38621:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you change the USB cable to a USB 2.0 cable to run the BootProgrammer application as a USB2.1 device.
If this does not work, the SupreSpeed Explorer Kit hardware may be damaged. Please try with another Kit if you have.
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is good to program in RAM.
I've tried the i2C program several times.
Can I not use I2C program if there is a problem with USB connection?
For example, if you are connected to USB2.0 instead of USB3.0, or the USB device driver is installed incorrectly.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When the PC is connected to the "Cypress FX3 USB Bootloader Device" the device is recognized as a USB 2.0 device.
When you select the menu item "Program->FX3->I2C EEPROM" a utility program named "BootProgrammer" is downloaded to the FX3 then PC recognize the FX3 as a USB 3.0 device "Cypress FX3 USB BootProgrammer Device"
If you don't see this device on the Control Center, the device driver may not be installed correctly. After that the "Select file to download..." dialogue is popped up to select the IMG file to be downloaded. Please confirm if the BootProgrammer Device is recognized by PC.
Regards,
Noriaki
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After selecting Program-I2C EEPROM, I confirmed that it recognizes as "Cypress FX3 USB BootProgrammer Device".
I then selected the file and the message "Progamming fo I2C EEPROM Failed" appears at the bottom of the figure.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you change the USB cable to a USB 2.0 cable to run the BootProgrammer application as a USB2.1 device.
If this does not work, the SupreSpeed Explorer Kit hardware may be damaged. Please try with another Kit if you have.
Regards,
Noriaki