- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to know whether the fx3 development board can receive a command from PC while it is busy is streaming video. If it is possible then whether the streaming will be halted or continued simultaneously while receiving command
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I hope by 'receive a command from PC', you mean a control request.
If fx3 enumerated as 2.0 device:
Then, the BULK channel will be suspended during the handling of control transfer. Streaming is halted for some duration.
If fx3 enumerated as 3.0 device:
Then, both can happen simultaneously with interruption to streaming.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I hope by 'receive a command from PC', you mean a control request.
If fx3 enumerated as 2.0 device:
Then, the BULK channel will be suspended during the handling of control transfer. Streaming is halted for some duration.
If fx3 enumerated as 3.0 device:
Then, both can happen simultaneously with interruption to streaming.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the information. I will be happy if I find those information
in some document or any datasheets. so, can you suggest me a documents
which speak reading these information.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer to Section 2.3 -> IV -> Point 2 of FX3_SDK_TroubleShooting_Guide.pdf in the following path:
"InstallPath\EZ-USB FX3 SDK\1.3\doc\firmware"
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you,
Information is so useful for me.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
what is the maximum size of video frame can be sent over the fx3 USB 3.0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The GPIF of FX3 can run at a maximum rate of 100MHz. If the data bus width is 32, then the maximum possible bandwidth would be 400MB/s.
You have to consider the following to decide whether streaming can be done:
1. Your image data rate: (H active in bytes) * (V active in bytes) * fps should not exceed the bandwidth possible over GPIF.
2. (One line data in bytes)/(Total Horizontal Time) gives you the average data rate that is needed on USB bus. You have to make sure that this is achievable on the USB bus.
3. Make sure that the line size in bytes is a multiple of GPIF data bus width selected.
4. With the AN75779 GPIF state machine you have to make sure that the vertical blanking is atleast 500uS.
4K resolution can also be streaming, providing all of the above are taken care.
Regards,
Hemanth