USB Superspeed Peripherals

cancel
Showing results for 
Search instead for 
Did you mean: 
Ask a question

Recent discussions

Sort by:
arnova2
USB Superspeed Peripherals
Background: I'm designing an interface where I paired an FPGA with the FX3. I opted to use the "Synchronous Slave FIFO Interface" to interface with th... Show More
mgiacomelli
USB Superspeed Peripherals
I am thinking about ways to verify that data is acquired continuously and for the host to recover in the event of a fault due to excess CPU load, USB ... Show More
vsarr
USB Superspeed Peripherals
Hello there, I am using a CYUSB3014 as a synchronous slave fifo interface to an Altera FPGA master. I have modified the 2-bit slave fifo sync firmware... Show More
arnova2
USB Superspeed Peripherals
I'm using vendor commands (implemented in the setup callback function) to implement i2c register read/write to/from my FPGA. I was wondering: How does... Show More
Rohanth
USB Superspeed Peripherals
Hello Team, I'm trying to stream 1080P MIPI Raw 10 image sensor . I if configure the MIPI transmitter section and receiver section for 1080p 30 Fps Th... Show More
Rohanth
USB Superspeed Peripherals
Hello,  I'm trying to stream MIPIraw 10 1920X1080 60fps in CX3 Denebola kit, When I tried to tried to stream camera in Linux host I got CB failure. Ki... Show More
JuFr_1923916
USB Superspeed Peripherals

Hi, I would like to know if cypress is planning the EOL of the CYUSB3014-BZXI.


Thanks in advance,


Juanjo

Adamk123
USB Superspeed Peripherals

Hi,


Is there any way to disable SSC on FX3 ? 

GrAU_4638336
USB Superspeed Peripherals
Hello, Through different questions already asked on your website, we have been able to solve majority of our issues. However, for the custom we are cu... Show More
ZaTu_4258396
USB Superspeed Peripherals
Good afternoon,   I am currently working on getting a new camera working on the same Cypress CX3 chip. We have created a very similar board to the one... Show More