USB Superspeed Peripherals

Showing results for 
Search instead for 
Did you mean: 
Ask a question

Recent discussions

Sort by:
USB Superspeed Peripherals
hi, Last time i issue a problem is : Show More
USB Superspeed Peripherals
Hi,I am sending/receiving data to/from UART to bulk end points. Every thing works well when I use control center.But when I use the same setup with cy... Show More
USB Superspeed Peripherals
Hello all, I found in CyUsb3.pdf the instructions to configure the inf file, although I don't have much experience with inf files in general. I've add... Show More
USB Superspeed Peripherals
Hello, During write transfer (Fx3 to PC), despite having full buffer (indicated by asserted DMA READY flag). After partial flag is asserted i keep wri... Show More
USB Superspeed Peripherals
Hello, We have been using CYUSB3014-BZXI and EZ-USB FX3 SDK 1.0 version. The problem is it takes long time (about 250msec) in function CyU3PUartTransm... Show More
USB Superspeed Peripherals
SX3 software is currently supported by EZ-USB SX3 Configuration Utility. Do you plan to release an FX3 like Software Development Kit for SX3? As I und... Show More
USB Superspeed Peripherals
When I use GPIF-II sync slave fifo interface with 2-bit address mode, I can successfully set watermark values for the four threads / P-port sockets. J... Show More
USB Superspeed Peripherals
Hi, I'm making code to test i2c write operation. FX3 is sending out data to external FPGA through i2c and if FPGA receive data, turn on the led connec... Show More
USB Superspeed Peripherals
Hello everyone, In my current project, I am required to send 16 bits data from a FIFO inside FPGA (Cyclone  IV E) to PC through FX3. I followed AN6597... Show More
USB Superspeed Peripherals
Hi, I am interfacing an Omnivision image sensor (OV9734) with the CX3 bridge . The image sensor and current cx3 receiver configuration are like below:... Show More