cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

ArSa_3842301
New Contributor II

Hello, I am reading the schematic board of Denebola kit, and I have a simple question. Why some of  cx3's VSS pins are connected to GND by 0E? I mean, if you put a resistor between GND and Vss pin, you will probably have more ground bounce because of the resistor's inductance. It is not better, to connect GND and Vss pin directly by wire, how does it happen with other Vss pins in the same schematic?.

Thanks so much.

0 Likes
1 Solution
cycy_1740621
Contributor

Hi Ara,

I think the 0-ohm resistor here is for testing, i.e., the current, noise and so on.

You do not need to do the same in your design.

View solution in original post

0 Likes
1 Reply
cycy_1740621
Contributor

Hi Ara,

I think the 0-ohm resistor here is for testing, i.e., the current, noise and so on.

You do not need to do the same in your design.

View solution in original post

0 Likes