Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Hi, I need to develop a USB3.0 system to transfer bulk data from FPGA to PC. Now I have the CYUSB3KIT-001 evaluation board and the Ulink2 (from Keil).Could I use the Ulink2 as the JTAG debugger to debug codes? Where can I download the driver?
I don't know the exact answer to your question. But I can point you to a document which has mentioned all the steps on how to use Seggar Jlink Probe with FX3 for debugging. Please refer to 12th chapter in the FX3 progammers manual.
Thank you for your reply. I also noticed the information to degug codes with JTAG from Segger. At present, I have a ULINK2 in hand, which supports the ARM9 processors. If it is possible, I want to make full use of the hardware.