Anonymous
Not applicable
Sep 02, 2012
10:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2012
10:22 PM
Hi,
I have read the document"Designing with the EZ-USB® FX3 Slave FIFO Interface".
It writes"Flags may be configured by EZ-USB FX3 firmware as empty, full, partially empty, or partially full signals. These are not
controlled by GPIF II states, but, rather, by the DMA hardware engine internal to FX3."
But in the fireware's API,I can't find any apis to config that.
Could you tell me how to config that?thank you.
2 Replies