Jun 14, 2021
05:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2021
05:50 PM
Hello
In conducting the USB compliance test,
Q1) Are there any registers that need to be checked to enable loopbacks and test patterns?
https://www.cypress.com/file/134661/download
Q2) There are two link test states (Loopback and Compliance mode), so I think there is a mode as FX3, but I don't know a concrete example of what to set and how.
Best Regards
Arai
Solved! Go to Solution.
Labels
- Labels:
-
USB Superspeed Peripherals
1 Solution
Jun 15, 2021
02:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2021
02:00 AM
Hi Arai-san,
Please refer to this KBA :https://community.cypress.com/t5/Knowledge-Base-Articles/Procedure-for-USB-3-1-Tx-and-Rx-Compliance-...
Best Regards,
AliAsgar
1 Reply
Jun 15, 2021
02:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2021
02:00 AM
Hi Arai-san,
Please refer to this KBA :https://community.cypress.com/t5/Knowledge-Base-Articles/Procedure-for-USB-3-1-Tx-and-Rx-Compliance-...
Best Regards,
AliAsgar