Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I use the 'DR_ADDR' and use the 'threadsocket' as the address source.In the GPIF II designer project,i use 'DMA_RDY_ADDR' to check where the address source is valid,but i do not know how to give some address words to address source in the firmware project.
Hi,thanks for answer.you say use the thread 0,but in 'gpif2_designer_userguide.pdf' has 'Available only when number of address bits is set to 0' and i set the address number is 8.Is it affect? And you say i can use DR_GPIO,but how can i give some words to these pins?