Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
i have done a fx3 PCB,when i connect to the pc,the control center can be distinguish it,but when i reset with the reset pin,the control center can not distinguish it,and when i download the firmware ,the control center can not distinguish it .i do not know what is the problem,i have tried to change another chip,but is also with the same problems.
Does this happens when you do a RAM download also? Can you check which version of the driver your device is binding to? Did you get your schematics and layout verified by Cypress. Create a tech support case in Cypress.com to debug this issue further.