- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using the following cx3 firmware with the danebola board and an ov5640 sensor to stream raw image data to the streamer app:”
https://community.cypress.com/thread/16971
I am seeing mostly failures in the streamer app when the packets per xfer and xfers to que are set to 256 and 64. Can you give me some suggestions how to get it to stream without failures?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I understood that you are streaming the RAW video data. It can be done using the UVC class drivers instead of Vendor class drivers.
In the case of UVC class, the device can mimic the host as UVC class device and send the RAW format data.
Here, you need to customize the UVC host application to stream the RAW video data.
You may refer to this.
Streaming RAW10 Format Input Data to 16/24-bit Output Format in CX3 MIPI CSI-2 - KBA224387
You may use open source UVC host application https://mpc-hc.org/ and do the necessary changes to display RAW video data.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I understood that you are streaming the RAW video data. It can be done using the UVC class drivers instead of Vendor class drivers.
In the case of UVC class, the device can mimic the host as UVC class device and send the RAW format data.
Here, you need to customize the UVC host application to stream the RAW video data.
You may refer to this.
Streaming RAW10 Format Input Data to 16/24-bit Output Format in CX3 MIPI CSI-2 - KBA224387
You may use open source UVC host application https://mpc-hc.org/ and do the necessary changes to display RAW video data.