Feb 28, 2020
06:28 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 28, 2020
06:28 PM
In figure 27 of "001-87216_AN87216_Designing_a_GPIF_II_Master_Interface.pdf", pin 5 of J6 is removed. In the schematics for that board, pin 5 of J6 is GND, the why is it removed? (There is no problem to remove it, but there seems to be no reason to remove it too)
Solved! Go to Solution.
1 Solution
Feb 28, 2020
07:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 28, 2020
07:51 PM
Hello,
In the Superspeed explorer kit, pin 5 of both J6 and J7 are blocked. This is the reason why pin 5 of J6 and J7 are removed in Fig 27 of AN87216.
Best Regards,
Jayakrishna
Best Regards,
Jayakrishna
Jayakrishna
2 Replies
Feb 28, 2020
06:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 28, 2020
06:54 PM
The reason is that pin is blocked in the header.
Feb 28, 2020
07:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 28, 2020
07:51 PM
Hello,
In the Superspeed explorer kit, pin 5 of both J6 and J7 are blocked. This is the reason why pin 5 of J6 and J7 are removed in Fig 27 of AN87216.
Best Regards,
Jayakrishna
Best Regards,
Jayakrishna
Jayakrishna