Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
1. Set as shown above in the code, also compiled using the FX3 SDK 2. Run the compiled images from the test board. 3. Check the return data from a function CyU3PGpifLoad apiRetStatus = CyU3PGpifLoad(&Sync_Slave_Fifo_2Bit_CyFxGpifConfig);
SDK ver 1.3.1 : CY_U3P_SUCCESS SDK ver 1.3.3 : CY_U3P_ERROR_NOT_SUPPORTED /* if a 32 bit GPIF configuration is being used on a part that does not support this */
In order to use 32bit FX3 SDK v1.3.3, Is there a need to set up? Will that make any difference to the library 1.3.1 and 1.3.3?
Library folder "C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\firmware\u3p_firmware\lib" of files, "ver 1.3.1" if the file to be replaced, CY_U3P_SUCCESS the return will be.