- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All!
I'm trying to figure it out how make my own application by "Slave FIFO Interface" Example.
I use AN65974 document: "Designing with the EZ-USB FX3 Slave FIFO Interface".
I have "cyfxgpif2config.h" header generated by GPIFII Designer.
The AN65974 document says next: "This header file must be included in the firmware project" (Part 10 on page 23).
Also AN65974 says "The EZ-USB FX3 SDK includes a firmware example that integrates the Slave FIFO
interface".
I was trying to figure out how I can integrate this header into the firmware project by studying "SYNCHRONOUS SLAVE FIFO PROTOCOL EXAMPLE", but I couldn't figure out how to do it.
Help me please understend how I can integrate "cyfxgpif2config.h" header into the firmware project.
Solved! Go to Solution.
- Labels:
-
USB Superspeed Peripherals
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
To use the custom cyfxgpif2config.h generated by the GPIF Designer tool following are the steps
- Copy the cyfxgpif2config.h in the slave fifo project folder
- comment out the previously included GPIF state machine header file (default) in in the main source file of the firmware (for example: cyfxslfifosync.c)
- include the header file in the main source file of the firmware (for example: cyfxslfifosync.c)
#include "cyfxgpif2config.h"
- Check if the parameters passed to CyU3PGpifSMStart is same as the one in the custom header file (cyfxgpif2config.h)
Rashi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
To use the custom cyfxgpif2config.h generated by the GPIF Designer tool following are the steps
- Copy the cyfxgpif2config.h in the slave fifo project folder
- comment out the previously included GPIF state machine header file (default) in in the main source file of the firmware (for example: cyfxslfifosync.c)
- include the header file in the main source file of the firmware (for example: cyfxslfifosync.c)
#include "cyfxgpif2config.h"
- Check if the parameters passed to CyU3PGpifSMStart is same as the one in the custom header file (cyfxgpif2config.h)
Rashi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank You alot!