- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would like to change USB mode between USB 2.0 and 3.0 base on SDK 1.3.4 demo module " cyfxbulklpmandcache" , but it cannot be successful.
It always return error.
Could you help me with it? Attached file is for your reference.
Very appreciate.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
EDITED:
Hello,
Can you please share the UART debug logs of the issue that you are facing or share the snapshot of the error that you are mentioning?
Also, i tried the firmware that you have attached and i noticed that you have commented out the DisableUSB20connection() function in the ReConnectUSBphy() function.
Please uncomment it and then try using checking the USB mode change from USB 3.0 to USB 2.0 and then again to USB 3.0.
After uncommenting the function i am able to see the USB transitions of the USB PHY as expected.
Regards,
Yashwant
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
EDITED:
Hello,
Can you please share the UART debug logs of the issue that you are facing or share the snapshot of the error that you are mentioning?
Also, i tried the firmware that you have attached and i noticed that you have commented out the DisableUSB20connection() function in the ReConnectUSBphy() function.
Please uncomment it and then try using checking the USB mode change from USB 3.0 to USB 2.0 and then again to USB 3.0.
After uncommenting the function i am able to see the USB transitions of the USB PHY as expected.
Regards,
Yashwant