Regarding FX3 Controller and CCG4M PD Controller

[SuWa_3337731]

Hi,

We are using CCG2 controller to negotiate the voltage over
USB3.1 power line from 5V to either 5/12/15/20V. In existing design I2C
interface of CCG2 controller is connected to FX3 controller (CYUSB3035-BZXC).

The USB data lines from USB type-C connector are connected
to FX3 controller are connected through external Mux/Demux switch.

At the time of design, we took reference from the attached
reference explorer kit and used the same Mux/Demux switch as used in this
reference kit.

Please let us know if we can replaced CCG2 controller and
existing external Mux/Demux with CCG4 PD controller (http://www.cypress.com/products/ez-pd-ccg4m-two-port-usb-type-c-controller-pd-and-high-speed-mux)
and connect with FX3 controller (CYUSB3035-BZXC).

Also, please let us know if there is any explorer kit or
reference design available for the CCG4 controller?

Thanks & Regards,

Sunny Watts

[RajathB_01 · Accepted solution]

Hi Sunny,

Please follow up on an earlier thread created on the same topic by you - Regarding FX3 Controller and CCG4M PD Controller

Locking this thread so that we can concentrate on one.

Regards,

Rajath