- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is regarding Cypress USB Superspeed peripheral controller FX3 (MPN: CYUSB3035).
We are already using this part in our couple of designs. In our existing designs, we connected VBUS and VBATT pin to 5V (Vbus voltage coming from USB connector).
As per datasheet of FX3 controller, VBATT pin can be connected to 3.3V battery supply.
We are planning to connect VBus with 5V (5V coming from USB connector) and VBATT pin with 3.3V on-board battery.
We would like to check if FX3 controller can operate with VBATT voltage only if voltage of VBUS pin is not available. In this case, can we use I2C interface of the controller?
Thanks & Regards,
Sunny Watts
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Sunny Watts,
FX3 controller can operate with VBATT voltage only.
Yes,you can use I2C interface of the FX3.but you should enable the Vbatt signal in the FX3 firmware.
void CyFx3BootUsbVBattEnable ( CyBool_t enable ) API is used to used to enable/disable the Vbatt power input to the USB block. If enable is CyFalse then Vbatt signal is connected to the USB block.
Regards,
Anil Srinivas.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Sunny Watts,
FX3 controller can operate with VBATT voltage only.
Yes,you can use I2C interface of the FX3.but you should enable the Vbatt signal in the FX3 firmware.
void CyFx3BootUsbVBattEnable ( CyBool_t enable ) API is used to used to enable/disable the Vbatt power input to the USB block. If enable is CyFalse then Vbatt signal is connected to the USB block.
Regards,
Anil Srinivas.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Anil,
Thanks for the quick response.
I would like to discuss the system requirement in detail for FX3 along with a power delivery controller.
Can you have tele-discussion or webex/Skype meeting?
Thanks & Regards,
Sunny Watts
Keysight Labs - RoQ, Bias & Controls
Telnet: 1-268-2572
DID: +91-124-4862572
Cell: +91-9999907724