Anonymous
Not applicable
Jul 17, 2012
05:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 17, 2012
05:38 AM
I have self-powered USB device running on FX2. Everything works except reconnection after USB cable is plugged out. When I plug-in the cable, device is not recognized on the host side and I have to power it down and up again to get it working.
I have implemented VBUS monitoring so device controls DISCONNECT bit. Except for that, what else should be done on the device side when "disconnected" and "connected" conditions are detected?
Help, anyone?
7 Replies