cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

Anonymous
Not applicable

Hi,

   

I have read the application notes AN84868 -- Configuring an FPGA Over USB Using Cypress EZ-USB FX3. I also referred to the Xilinx Spartan-6 FPGA Configuration User Guide. Over the FPGA, there are mode pins M[1:0] used to select certain mode to configure FPGA. For example, M[1:0] = 11 indicates slave serial mode. However, in the application notes AN84868, there is not a discussion about M[1:0]. How should I set M[1:0], follow the Xilinx Configuration guide or just ignore?

   

 

   

Best Regards
Zoe

0 Likes
1 Reply
Anonymous
Not applicable

Hi  Zoe,

   

You can either select the M0 and M1 pins either both ON, or both OFF. It does not matter in this application. So basically you can ignore these switches.

0 Likes