- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am using Denebola board for our development. But I am not able to Flash that binary into Denebola board. To flash firmware into Denebola board we refer "Firmware_build manual.pdf" but still I am not able to flash that binary into the board. When we open USB Control Center from FX3 sdk we are not able to select device type from that panel. I attached screen shot of same please let me how to solve this issue.
Thanks,
Amit
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Amit,
"Cypress Bootloader Device" should come up in Universal Serial Bus Controllers list. Please check the driver details of the Cypress Bootloader device, it must bound to CYUSB3.sys driver. If not, try to forcefully bind the driver to CyUSB3.sys driver.
If issue persists then please uninstall the IAR software and power cycle the device.
Thanks & Regards
Abhinav