Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I have a generic question about the BulkLoopManual test. Looking at the test and at a CATC trace, i do not see any SetConfig command. I was under the impression that you had to do a Set Config before using any data endpoints.
You're talking about the SET_CONFIGURATION request being sent by the host right?
Only in cases where there are alternate settings I've seen hosts send this particular request. Some hosts don't send this request for some reason. Most hosts do that even if there are no alternate settings.
But in the application code/driver that I have written, I always try to make sure I do a set configuration to make sure my device is correctly enabled. This is probably working since this is config 0 and not a config 1 or something.