- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a generic question about the BulkLoopManual test. Looking at the test and at a CATC trace, i do not see any SetConfig command. I was under the impression that you had to do a Set Config before using any data endpoints.
Ken
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You're talking about the SET_CONFIGURATION request being sent by the host right?
Only in cases where there are alternate settings I've seen hosts send this particular request. Some hosts don't send this request for some reason. Most hosts do that even if there are no alternate settings.
Regards,
Anand
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
But in the application code/driver that I have written, I always try to make sure I do a set configuration to make sure my device is correctly enabled. This is probably working since this is config 0 and not a config 1 or something.