Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I am trying to find the maximum speed of transfer over the USB 3.0 to FX3 board using the USBBulkLoopAuto example.
I changed the max. no. of packets to 0x08 in the cyfxbulklpdscr.c file in the bulkloopauto example and used a USB traffic analyser called USBlyzer. And if what I understood is correct it gave me a speed of 40MBps.
I am using atmels AT24C1024B I2C EEPROM. However when I try to increase the data I send to more 8-9KB I am getting the error code: 997. Also when try to change the size of each packet to 2048 bytes the device manager gives an error message saying "this device cannot start (code 10). What isthe problem here? Is there a better way to findthe max speed of transfer usingthe bulk loopauto exampel specifically? or using the FX3 board as such?