- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'd like to make a non-uvc project.
I referred to the below link then make a project successfully.
However, I cannot build it with many errors even though I didn't add my own source yet.
I attached my project.
Please let me know what's the problem.
Regards,
Philip
Solved! Go to Solution.
- Tags:
- cx3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Philip,
I tried to develop a project with almost the same settings as yours and did not find any errors. Please find the project created at my end along with this response.
When I checked the properties of the project that was shared, I found that the Include paths and library search paths were not proper. Can you please try uninstalling the FX3 SDK once and then re-installing the latest SDK (1.3.4) from the following link:
https://www.cypress.com/documentation/software-and-drivers/ez-usb-fx3-software-development-kit
After installing the latest SDK, please check if you are still facing this issue.
Jayakrishna
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Philip,
I tried to develop a project with almost the same settings as yours and did not find any errors. Please find the project created at my end along with this response.
When I checked the properties of the project that was shared, I found that the Include paths and library search paths were not proper. Can you please try uninstalling the FX3 SDK once and then re-installing the latest SDK (1.3.4) from the following link:
https://www.cypress.com/documentation/software-and-drivers/ez-usb-fx3-software-development-kit
After installing the latest SDK, please check if you are still facing this issue.
Jayakrishna