- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
We currently have a board with a device using I2C slave address "0xA0". This generates a conflict with the boot EEPROM since they share the same address.
It seems like FX3 ROM uses "0xA0" address when booting from I2C. Is it possible to change this and boot from another I2C address?
Solved! Go to Solution.
- Labels:
-
USB Superspeed Peripherals
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to this thread Solved: Is it possible to change the EEPROM Slave Address ... - Cypress Developer Community
You can try powering up the other I2C slave once the FX3 is booted completely.
Rashi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to this thread Solved: Is it possible to change the EEPROM Slave Address ... - Cypress Developer Community
You can try powering up the other I2C slave once the FX3 is booted completely.
Rashi