cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

MeSr_4460526
New Contributor

Hi,

Can someone confirm if hardware strapping is required for JTAG pins?

In datasheet it is mentioned that JTAG TDI, TMC, and TRST# signal has fixed 50k internal pull-up resistor and TCK has fixed 10k pulldown resistor

Thanks,

Menaka

0 Likes
1 Solution
YashwantK_46
Moderator
Moderator

Hello Menaka,

I can confirm that CX3 doesn't need any external hardware strapping on the JTAG pins.

As mentioned in the datasheet, the JTAG pins: TDI, TMC, and TRST# signal has fixed 50k internal pull-up resistor and TCK has fixed 10k pulldown resistor.

Regards,

Yashwant

View solution in original post

0 Likes
4 Replies
Rakshith
Moderator
Moderator

Hi MeSr_4460526​,

Can you please let us know which device you are using?

For designing the schematic of your custom board you can refer to your respective device's hardware design considerations document.

Thanks and Regards,

Rakshith M B

Thanks and Regards,
Rakshith M B
0 Likes
MeSr_4460526
New Contributor

Hi Rakshith,

Thanks for the reply!

I am using CX3 in my design, can you please confirm if any hardware strapping is required for the JTAG pins of CX3/FX3?

Thanks,

Menaka

0 Likes
YashwantK_46
Moderator
Moderator

Hello Menaka,

I can confirm that CX3 doesn't need any external hardware strapping on the JTAG pins.

As mentioned in the datasheet, the JTAG pins: TDI, TMC, and TRST# signal has fixed 50k internal pull-up resistor and TCK has fixed 10k pulldown resistor.

Regards,

Yashwant

View solution in original post

0 Likes
MeSr_4460526
New Contributor

Hi Yashwant,

Thank you for the reply!

Regards,

Menaka

0 Likes