Is hardware strapping required for JTAG pins?

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
MeSr_4460526
Level 1
Level 1

Hi,

Can someone confirm if hardware strapping is required for JTAG pins?

In datasheet it is mentioned that JTAG TDI, TMC, and TRST# signal has fixed 50k internal pull-up resistor and TCK has fixed 10k pulldown resistor

Thanks,

Menaka

0 Likes
1 Solution

Hello Menaka,

I can confirm that CX3 doesn't need any external hardware strapping on the JTAG pins.

As mentioned in the datasheet, the JTAG pins: TDI, TMC, and TRST# signal has fixed 50k internal pull-up resistor and TCK has fixed 10k pulldown resistor.

Regards,

Yashwant

View solution in original post

0 Likes
4 Replies
Rakshith
Moderator
Moderator
Moderator
250 likes received 1000 replies posted 750 replies posted

Hi MeSr_4460526​,

Can you please let us know which device you are using?

For designing the schematic of your custom board you can refer to your respective device's hardware design considerations document.

Thanks and Regards,

Rakshith M B

Thanks and Regards,
Rakshith M B
0 Likes

Hi Rakshith,

Thanks for the reply!

I am using CX3 in my design, can you please confirm if any hardware strapping is required for the JTAG pins of CX3/FX3?

Thanks,

Menaka

0 Likes

Hello Menaka,

I can confirm that CX3 doesn't need any external hardware strapping on the JTAG pins.

As mentioned in the datasheet, the JTAG pins: TDI, TMC, and TRST# signal has fixed 50k internal pull-up resistor and TCK has fixed 10k pulldown resistor.

Regards,

Yashwant

0 Likes

Hi Yashwant,

Thank you for the reply!

Regards,

Menaka

0 Likes